Tuesday, May 5, 2020

Halloween 24/7

Yep. You know how you get a little itchy when you haven't done something Halloween related in a while?
No? Really?
Well, okay. But just to mix things up a bit, it's Halloween in May at my house.
Here's a fun thing I made using Gypsy Soul Laser Cuts super-sturdy-do-anything-on-'em Chunky ATC Blanks. I love these things. They are just about indestructible and put up with a lot of mixed media, sanding, painting over and general artsy masochism.
This is a straightforward project, so I wasn't so hard on the poor things this time, but I like the visual effect.
  They are fairly simple but I like the stark contrast of the black trees (I used the 3D Chip Board Tree-3inch and just a little black silhouette of a Halloween critter (which I just drew in with a good black marker) with some borders I cut from the Graphic 45 Rare Oddities Ephemera Cards.
Easy, but effective.
Here's where it began...
I then covered the fronts of the ATC's with my chosen papers.
I cut the borders from the G45 papers and cut the trees in half. I painted them black (some are white in the photo, but later I changed them to all black).
Please note that the borders are larger than the ATC's and that is okay.

Setting aside the trees to dry, I flipped the ATC's over, lined them up and glued a ribbon down the center of the ATC's, leaving enough ribbon at the top to loop over as a hanger.
Do a dry run of the frames on the ATC's with the frames and ribbon to make sure you've left enough space for you to glue the frames on to the ATC's and not have them overlap.
I chose to have very little space between each piece, but you might like more of the ribbon to show between each one. Your choice!
After the ribbon dried, I glued the frames and the trees on the front, making sure the frames were centered as best I could make them on the ATC's. 
After the trees dried I drew in some simple Halloween shapes with a pencil and went over them with a very black marker.
I chose a bat, a cat and a spider, but you can let your creepy critter flag wave here and choose whatever you like.
Not to waste, I finished off the backs with the center pieces I cut out of the G45 ephemera cards.

Simple but effective.
Going for the simple design that has visual impact.
Hope you like it!
Thanks for dropping by.

SUPPLIES:
Chunky ATC Blanks
3D Chip Board Tree-3inch 
Graphic 45 Rare Oddities Ephemera Cards
Ribbon
Black paint
Black marker